Water can wreak havoc on any property if not controlled - here are the most common plumbing issues we see.
Plumbing issues can range from a rapidly flooding basement to a small leak. All of these issues should be addressed as a homeowner, some more quickly than others. Water can be very damaging very quickly.
Before we dive into the list of common plumbing emergencies and what to do, there are a few items you should be familiar with at your property. The most important is the location of the main water supply. This is critical to know if there’s ever a plumbing emergency (and helpful for other plumbing issues as well). Its best to know how to shut off the main water line, we recommend doing a test run to be sure.
It’s also important to know the basics of your water heater: how to turn it on and off, how to increase the water temperature, where the pilot light is - basic troubleshooting.
A pipe can burst when too much water pressure builds up at a weakened joint. Pipes also burst in the winter when leftover water expands when frozen, hence the importance of insulating exterior pipes and interior pipes that are exposed to the cold. More likely than not you will know when a pipe has burst - it can make a loud popping noise, otherwise, there will be significant leaking. Burst pipes need to be addressed immediately. Turn the main water line off to stop the leak and call a plumber as soon as possible. After the water has been shut off it’s best to drain all the faucets and do your best to clean up the water. Let in as much warm air as possible to dry out the area around the leak.
No Hot Water
A lack of hot water is a little more tricky to diagnose - many things can cause this. Here are a few items to look at:
What is your water temperature set to? If it’s below 120 degrees F you may want to turn up the heat - temps below that 120 degrees F mark can also cause bacterial growth in your tank. Don’t go above 140 degrees F for the risk of burning.
Check the pilot light. If you have a gas water heater, it will have a pilot light - if it’s out it will need to be re-lit. New heaters will have an ignition switch, older models may require you to light manually. Reference the user manual when relighting the pilot.
Flush the water heater. Over time sediment and other buildups can cause your water heater to not be effective. Again, take a look at the user manual on directions for flushing your tank - this may or not be a job a landlord is up to.
Water pooling around the heater. If you can see a leak or determine that the pooled water is coming from your heater, this should be fixed. We recommend calling a plumber - the leak will get worse and worse with time.
Broken Water Line
A busted water line is a major headache for a homeowner. These are not easy fixes and are typically quite expensive. Here are some indicators that your water line needs repair:
Poor water pressure. If you notice the water pressure is lower than normal, it could be because there’s a leak. If there are no other signs of water damage or a leak in the property it may be the water line. Bringing out a pro to scope your line is the next step to take.
Increasing water bills. If you notice the water bill going up, it’s because water may be leaking into the ground. Hopefully, the city can alert you of any significant changes but, again, bring out a plumber to look at your water line.
Soggy ground. If you notice soft spots or water build-up in the front lawn, for example, the water line may be broken.
Water can be one of the most damaging elements on any property. Make sure to keep a close eye on your plumbing systems and check for signs of malfunction often.